Se establece una metodología a nivel de laboratorio para sintetizar un polímero híbrido poli(glicerol itaconato) (PGItc) utilizando celulosa nanofibrilada (NFC) suspendida en glicerina con el objetivo de estudiar el reforzamiento mecánico de la matriz de poli(glicerol itaconato) por las nanofibras de celulosa. Se sintetiza el material en concentraciones de 1% y 2% de masa de NFC en glicerina. Se llevó a cabo un proceso de cambio de solvente para diluir NFC en glicerina, y posteriormente se sintetiza PGItc utilizando anhídrido itacónico, polimerizando con la glicerina/NFC. Se caracterizaron mecánicamente los materiales mediante el cálculo del Módulo de Young, obteniendo que los materiales híbridos poseen módulos de 1,78 y 3,54 MPa a 1% y 2% de NFC respectivamente, mostrando un aumento en comparación al material puro que posee un módulo de 0,613 MPa. Un análisis fue realizado para medir el efecto de la carga de nanocelulosa en las propiedades de autocuración del polímero. Utilizando una muestra con carga de 1% NFC se comprobó que el material híbrido mantiene sus propiedades de autocuración, posiblemente mediada por reordenamiento dinámico de enlaces éster. El procedimiento y análisis mostraron resultados satisfactorios, sin embargo, los datos obtenidos muestran poca consistencia, por lo que se propone para estudios futuros la utilización de métodos más modernos de síntesis y curado posterior, de manera que se pueda disminuir la variabilidad de los resultados.
A laboratory level methodology is established to synthesize a hybrid polymer poly(glycerol itaconate) using NFC suspended in glycerin with the objective of studying the mechanical reinforcement of the poly(glycerol itaconate) matrix by cellulose nanofibers. The material was synthesized at 1% and 2% mass concentrations of NFC in glycerol. A solvent change process was first conducted to dilute NFC in glycerol, and then PGItc is synthesized using itaconic anhydride, polymerizing with the glycerol/NFC. The materials were mechanically characterized by calculating Young's Modulus, obtaining that the hybrid materials have moduli of 1.78 and 3.54 MPa at 1% and 2% of NFC respectively, showing an increase in its tensile strength compared to the pure material that has a modulus of 0.613 MPa. 3 An analysis was performed to measure the effect of nanocellulose load on the self-healing properties of the polymer. Using a 1% NFC loaded sample, the hybrid material was found to maintain its self healing properties by rearrangement of C-O bonds and breaking of double bonds into covalent C-C bonds. The procedure and analysis showed satisfactory results, however, the data obtained showed little consistency, so it is proposed for future studies the use of more modern methods of synthesis and subsequent curing, so that the variability of the results can be reduced.