Tesis Magíster
Permanent URI for this collection
Browse
Browsing Tesis Magíster by Author "Cañumir Veas, Juan Antonio"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Evaluación del efecto de la temperatura sobre el rendimiento y la eficiencia de conversión energética en exteriores de tres tecnologías fotovoltaicas durante el periodo estival en la zona centro sur de Chile.(Universidad de Concepción, 2021) Medina Correa, Roberto; Cañumir Veas, Juan AntonioEn este documento se llevó a cabo un estudio comparativo del desempeño energético de tres tecnologías fotovoltaicas con el objetivo de determinar cuál se adecua mejor a las condiciones climáticas presentes en el periodo estival de la zona centro sur de Chile. Las tecnologías que se compararon estaban compuestas por módulos fotovoltaicos de silicio amorfo (a-Si), silicio policristalino (poli-Si) y silicio monocristalino (mono-Si). La irradiación incidente sobre los módulos fotovoltaicos para los meses enero, febrero y marzo presentó una media diaria mensual de 7,4 kWh/m2 ± 1,6, 6,7 kWh/m2 ± 1,7 y 6,4 kWh/m2 ± 1,6 respectivamente. El total de energía generada fue de 128,1 kWh, 127,6 kWh y 87,6 kWh para las tecnologías de poli-Si, a-Si y mono-Si respectivamente, siendo este último el de menor potencia nominal instalada. Se encontró en dicho periodo que a-Si tiene una eficiencia normalizada ligeramente mayor de 4,3% sobre poli-Si y 8,9% sobre mono-Si. Así mismo, el valor de Performance Ratio para a-Si poli-Si y mono-Si fue de 0,91, 0,79 y 0,75 respectivamente. En otro ámbito, los coeficientes de pérdidas de potencia máxima por temperatura obtenidos mediante los datos experimentales extraídos en terreno tienen valores de -0,21%/°C, -0,50%/°C, -0,45%/°C para a-Si, poli-Si y mono-Si respectivamente.Item Tecnología de burbujas finas y ultrafinas: actuales y potenciales aplicaciones en el área agroindustrial.(Universidad de Concepción, 2020) Vásquez Benavides, María Ignacia Margarita; Cañumir Veas, Juan AntonioIn recent years, great efforts have been made to find an ideal method for the characterization of fine bubbles (FB) and ultrafine bubbles (UFB). In this investigation, two technologies were applied to characterize the bubbles: dynamic light scattering (DLS) and transmitted light microscopy. The characterization by using DLS evidenced the presence of another particles in suspension other than bubbles, however, it was possible to demonstrate the presence of the FB and UFB, thanks to the differences between blank samples and bubble samples. In general, there was a tendency to increase the diameter of the bubbles over time. A slight change in pH did not show significant differences in the results. The ζ potential (zeta potential) results, showed erratic behavior, but the existence of negatively charged suspended bubbles was verified. By using transmitted light microscopy, the existence of FB and UFB, naturally found in the UPW-Methylene blue control sample was discovered, of which 98% corresponded to diameters less than 1 μm. On the other hand, a higher concentration of bubbles was found in the UFB-Methylene blue sample, of which 94% corresponded to diameters less than 1 um. The applications of BF and BUF that have been reported in recent years, in different areas of science, can be extrapolated to the agroindustrial area.